- Poster presentation
- Open access
- Published:
The consequences of denoising marker-based metagenomic data
BMC Proceedings volume 6, Article number: P11 (2012)
Background
Early marker-based metagenomic studies, such as those of the human microbiome, were performed without properly accounting for the effects of noise (pyrosequencing errors, PCR single-base errors, and PCR chimeras). One popular solution to address these issues is to utilize AmpliconNoise [1]. This collection of algorithms was validated on mock community datasets in which the 'correct' result, such as the number of operational taxonomic units (OTUs), was known. However, when conducting a real study, one will not know the correct result, but still must consider how the data has been transformed by denoising.
Materials and methods
We applied AmpliconNoise to several real metagenomic datasets. At each stage of the pipeline, we reconstituted the reads and determined how they had been affected. The changes were quantified as substitutions, insertions, deletions and '3' gap', which is the number of bases removed from (or added to) the 3' end of a read. We further analyzed the effects of the related denoising programs in QIIME (Denoiser [2]) and in mothur [3].
Results
The preliminary filtering steps of AmpliconNoise caused most of the sequence reads to be eliminated or truncated. Following this, the algorithm PyroNoise caused changes to the reads that were inconsistent with the known spectrum of pyrosequencing errors, until one of the parameters was increased substantially. Additionally, because PyroNoise mapped reads onto longer representatives, sequences were added to the 3' ends of reads that were often dissimilar from those that were removed by the truncations of the filtering steps. After this, SeqNoise, which was designed to remove PCR single-base errors, further clustered the reads and caused even more changes to the reads with little justification.
Denoiser, which is based on an earlier version of AmpliconNoise, caused far more changes to the data. The evaluation of the changes was not as clear here, since they were not clearly delineated as to which type of errors they were correcting, but we found some of the same flawed methodology that produced much of the negative effects seen in AmpliconNoise. This was also true of the denoising programs in mothur, which were recoded directly from the AmpliconNoise algorithms.
Conclusions
While reducing the effects of noise in the analysis of marker-based metagenomic data is important, the algorithms of AmpliconNoise make changes to sequence reads that are inconsistent with simply removing noise. We recommend that those using AmpliconNoise be cognizant of the possible side effects and, at a minimum, consider adjusting the parameters of the algorithms accordingly.
References
Quince C, Lanzen A, Davenport RJ, Turnbaugh PJ: Removing noise from pyrosequenced amplicons. BMC Bioinformatics. 2011, 12: 38-10.1186/1471-2105-12-38.
Reeder J, Knight R: Rapidly denoising pyrosequencing amplicon reads by exploiting rank-abundance distributions. Nat Methods. 2010, 7: 668-669.
Schloss PD, Gevers D, Westcott SL: Reducing the effects of PCR amplification and sequencing artifacts on 16S rRNA-based studies. PLoS One. 2011, 6: e27310-10.1371/journal.pone.0027310.
Author information
Authors and Affiliations
Rights and permissions
This article is published under license to BioMed Central Ltd. This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
About this article
Cite this article
Gaspar, J.M., Thomas, W.K. The consequences of denoising marker-based metagenomic data. BMC Proc 6 (Suppl 6), P11 (2012). https://doi.org/10.1186/1753-6561-6-S6-P11
Published:
DOI: https://doi.org/10.1186/1753-6561-6-S6-P11